The following guide outlines the steps necessary to install & configure Anonine using IPsec on your Ubuntu 16.04:
1. Install StrongSwan
Open terminal and run this commands one by one:
sudo -s apt-get update apt-get -y install strongswan apt-get -y install strongswan-plugin-eap-mschapv2 apt-get -y install libcharon-extra-plugins apt-get -y install libstrongswan-extra-plugins
2. The following command will replace default configuration file and write required settings.
Change the following information and run a command:
'conn anonine' - Enter a name for the connection you are adding. IE. Anonine
'eap_identity=username' - Enter your Anonine user name.
'right=server address' - Enter the PPTP or L2TP server address of the location/server that you wish to connect to from our server list
sudo printf '%s\n\t' 'conn anonine' 'keyexchange=ike' 'dpdaction=clear' 'dpddelay=300s' 'eap_identity=username' 'leftauth=eap-mschapv2' 'left=%defaultroute' 'leftsourceip=%config' 'right=pt-pptp.anonine.net' 'rightauth=pubkey' 'rightsubnet=0.0.0.0/0' 'rightid=%any' 'type=tunnel' 'auto=add' > /etc/ipsec.conf
After this execution of this command you will have configuration file /etc/ipsec.conf like this:
conn anonine keyexchange=ike dpdaction=clear dpddelay=300s eap_identity=username leftauth=eap-mschapv2 left=%defaultroute leftsourceip=%config right=pt-pptp.anonine.net rightauth=pubkey rightsubnet=0.0.0.0/0 rightid=%any type=tunnel auto=add
3. Disable the "constraints" plugin
sudo sed -i 's/load = yes/load = no/g' /etc/strongswan.d/charon/constraints.conf
4. Write your credentials into /etc/ipsec.secrets replacing username and password with your Anonine username and password
sudo printf '%s' 'username' ' : EAP ' 'password' >> /etc/ipsec.secrets
5. StrongSwan needs to verify server certificate. As it searches its certificates store, we can link it to the system's OpenSSL certificate store. To do so, execute the following commands:
sudo rmdir /etc/ipsec.d/cacerts sudo ln -s /etc/ssl/certs /etc/ipsec.d/cacerts
6. Restart StrongSwan daemon so it reads new settings:
sudo ipsec restart
7. To start the connection just type:
sudo ipsec up your_connection
To disconnect, type:
sudo ipsec down your_connection
Where your_connection is the name of connection you specified in step 2
You can always check the status of your connection by typing:
sudo ipsec status
Once you are connected you will see the message: "connection 'your_connection' established successfully"
All of your online activities are now 100% secure and anonymous while connected to Anonine.
If you have any questions, or experience any issues while installing and setting up your Ubuntu device to connect to
the Anonine VPN servers - please contact our Support Team anytime.